Comtech EF Data HPCST-5000 - Manual (Page 68)

Single Thread System Installation High-Power C-Band Satellite Terminal
3–14 Rev. 0
3.3.2.2 Square Pole
For square vertical pole installation, follow the steps in Section 2.3.2.1, with the
following exceptions:
! Do not perform Step 4.
! Do not perform Step 6.e.
3.3.3 Spar Installation
Note: Refer to Section 8, Equipment List, Figure 8-3 for assistance in the installation.
Install the RFT to a spar as follows:
1. Set the unit on its side, with the mounting holes facing up.
2. Install the 8” unistruts as follows:
a. Position an 8” unistrut (with the open
side facing up) over one set of the
mounting holes on the RFT.
b. Using four 1/4-20 x 1” bolts, 1/4”
split lockwashers, and 1/4” flat
washers, attach an 8” unistrut to the
RFT. Tighten the bolts firmly.
c. Repeat Steps 2.a. and 2.b. for the
second 8” unistrut.