Comtech EF Data HPCST-5000 - Manual (Page 113)

Rev. 0 5–1
5
Chapter 5.
OPERATION
This chapter provides operation information for the HPCST-5000 terminal system.
5.1 System Operation
There are three methods of operating the RFT-500:
! Connect a PC running DOS to the EIA-232/EIA-485 remote control port, and run
the M&C system monitor software. This software is DOS-based and provides an
interface to the remote commands.
For information on the remote commands, refer to Appendix B.
For more information on the M&C system monitor program, refer to the Monitor
and Control Software for EFData Satellite Terminals User’s Guide.
! Connect the optional KP-10 hand-held keypad. For more information, refer to
the KP-10 External Keypad Installation and Operation Manual.
! Use the optional front panel display/keypad (refer to Section 5.3).
5.2 Remote Control
Refer to Appendix B for information on remote control operation.