Comtech EF Data HPCST-5000 - Manual (Page 78)

Single Thread System Installation High-Power C-Band Satellite Terminal
3–24 Rev. 0
6. Mount the C-Band SSPA as follows:
a. Lift the C-Band SSPA
into position on the
vertical pole.
b. Slip a 14” unistrut
over each of pair of
threaded rods (upper
and lower).
Note: Install the 14”
unistruts with the open face
toward the pole as
illustrated below.
c. Install a 5/16” flat
washer, 5/16” split
lockwasher, and
5/16-18 nut on each
threaded rod.
d. Position the RFT as
desired, and tighten
the 5/16-18 nuts
installed in Step 6.c.
e. Slide the pipe blocks
inward until they
contact the vertical
pole, then firmly
tighten the 5/16-18
bolts.