Comtech EF Data HPCST-5000 - Manual (Page 103)

High-Power C-Band Satellite Terminal Redundant System Installation
Rev. 0 4–21
4.3.5 1:1 Redundant C-Band SSPA Installation
Refer to Section 8, Equipment List, Figure 8-6 for assistance in the installation of the
1:1 Redundant System. Refer to Figure 8-2 for the cabling configuration.
4.3.5.1 Round Pole
Note: The following process is for a typical installation.
Install the 1:1 redundant assembly C-Band SSPAs to a round vertical pole as follows:
1. Set the units on a suitable work bench with the cooling fan side up.
2. Install the mounting bracket as follows:
a. Position the mounting
brackets. Align the
mounting brackets
with the mounting bolt
holes.
CAUTION
Do not block the cooling fans with the mounting bracket. Damage
to the unit may be the result
b. Install four 3/8 x 11/4” bolts 3/8” split washers, and 3/8” flat washers.
c. Tighten bolts firmly.