Comtech EF Data HPCST-5000 - Manual (Page 39)

High Power C-Band Satellite Terminal Introduction
Rev. 0 1–23
1.9 C-Band SSPA Specification
Refer to Table 1-13 for C-Band SSPA specifications.
Table 1-13. C-Band SSPA Specifications
Parameter Specification
Power:
Power Requirements
Power Consumption
Power Factor Correction 90 to 230 VAC, 47 to 63 Hz, single phase
6A typical at 110 VAC
95%, minimum
Frequency Range 5.845 to 6.450 GHz
Power Output (P
1dB
) 75 W
48
100 W
49
125 W
50
150 W
51
Small Signal Gain 75 W
79
100 W
80
125 W
81
150 W
82
Gain Flatness (at room temperature),
maximum 2 dB P–P over 600 MHz
0.6 dB P–P over 40 MHz
Gain Slope 0.015 dB/MHz, maximum
Gain Variation
# 1.5 dB over frequency and temp range
Local Gain Adjustment
# 3 dB, minimum
Input Return Loss 19 dB, minimum
Output Return Loss 19 dB, minimum
Noise Figure at Maximum Gain 10 dB
Spurious Rated Power, maximum -65 dBc, maximum
Harmonic at rated power -60 dBc, maximum
AM/PM Conversion at Rated Power 2.5
!/dB
Third Order Intermodulation
(Two equal tones 5 MHz apart) -34 dBc at 6 dB backoff from rated P
1dB
-26 dBc at 3 dB backoff from rated P
1dB
Group Delay:
Linear
Parabolic
Ripple 0.02 ns/MHz
0.003 ns/MHz
2
1 ns P–P
Residual AM (F* = Frequency in kHz) -45 dBc
-20 (1+ log F*) dBc
-80 dBc 0 to 10 kHz
10 kHz to 500 kHz
500 kHz to 1 MHz
Phase Noise Meets IESS-308/-309