Comtech EF Data CRS-500 - Manual (Page 92)

CRS-500 1:N Redundancy System Revision 2
Cables and Connections MN-CRS500
4–36
• Connect the pertinent “Rx IF” connector on the modem to the connector labeled “Rx
REDUNDANT MODEMS | TO MODEM 1” on the CRS-282Rxx ISU.
Then, for each Traffic Modem, using the appropriate IF cables:
• Connect the “Tx# | FROM TRAFFIC MODEM” connector (where ‘#’ designates a TM
number from 1 to 10) on the CRS-282Txx ISU to the “Tx IF” connector on the modem,
and
• Connect the “Rx# | TO TRAFFIC MODEM” connector (where ‘#’ designates a TM number
from 1 to 10) on the CRS-282Rxx ISU to the “Rx IF” connector on the modem.