Comtech EF Data CRS-500 - Manual (Page 127)

CRS-500 1:N Redundancy System Revision 2
CSU Front Panel Operation MN-CRS500
7–11
1. Only the first 20 characters on the bottom line of each community screen
are available.
2. All printable ASCII characters are available with the exception of the
backslash ‘/’ (ASCII code 92) and tilde ‘~’ (ASCII code 126).
3. You must reboot the system in order for changes to the Read and/or Write
Community strings to take effect.
CONFIG: IP
 SNMP  Read
SNMP Read Community:
public
To edit the SNMP Read Community string, use the ◄ ► arrow keys to select the character to
edit, and then use the ▲▼ arrow keys to edit that character. Press ENTER when done. All
trailing spaces are removed from the Read Community string upon entry.
CONFIG: IP
 SNMP  Write
SNMP Write Community:
private
To edit the SNMP Write Community string, use the ◄ ► arrow keys to select the character to
edit, and then use the ▲▼ arrow keys to edit that character. Press ENTER when done. All
trailing spaces are removed from the Write Community string upon entry.
7.2.2.1.3.2 CONFIG: IP  Mdm-IP (Modem IP Address)
Mdm IP Addr for slot 01:
000.000.000.000/00
View or edit the Modem IP Address for switch-to-modem communication here.
To edit the Modem IP Address:
• On the top line, use the ◄ ► arrow keys to select the Slot (modem) to edit (01 through
11).
• Once you select the appropriate slot, use the ◄ ► arrow keys to first navigate to the
bottom line, and then use the ◄ ► arrow keys once more to select the digit to edit.
Finally, use the ▲▼ arrow keys to edit that digit.
• Press ENTER when done.