Comtech EF Data CRS-500 - Manual (Page 172)

CRS-500 1:N Redundancy System Revision 2
Serial-based Remote Product Management MN-CRS500
9–12
Parameter Type
Command
(Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(Note that all arguments are ASCII numeric codes, that
is, ASCII codes between 48 and 57)
Response to Command
(Target to controller)
Query
(Code and
qualifier)
Response to query
(Target to controller)
Restore Holdoff
Time
RSH= 2 bytes, numerical Command or Query.
Sets or returns the restore holdoff time, the delay when auto
mode prepares to return a modem (previously faulted, now
good) back online due to a different Traffic Modem’s failure, in
the form xx, where:
01-99 = # of seconds after offline Traffic Modem lost its
fault before it is put back online so that Redundant
Modem can bridge the newly faulted modem.
RSH=
RSH?
RSH*
RSH? RSH=xx
(see description of
arguments)
Switch Alarm
Mask
SAM= 1 byte, numerical Command or Query.
Sets or returns the Switch alarm mask in the form x, where:
0 = no faults masked
1 = Power Supply A faults masked
2 = Power Supply B faults masked
SAM=
SAM?
SAM*
SAM? SAM=x
(see description of
arguments)
Switch IP
Addresses
SIP= 20 bytes Command or Query.
Sets or returns the IP address and network prefix for the
10/100 BaseTx Ethernet management port of traffic and
backup modems, in the form uuxxx.xxx.xxx.xxx/yy, where:
uu is the unit #:
uu => 01-09 – IP address for traffic modem 1-9.
uu => 11 – IP address for redundant modem 1
uu => 10 – IP address for traffic modem 10
xxx.xxx.xxx.xxx is the IP address of the modem
yy is the network prefix (00..31)
SIP=
SIP?
SIP*
SIP#
SIP?uu SIP=uuxxx.xxx.xxx.xxx/y
y
Switching Mode SWM= 1 byte, numerical Command or Query.
Set or returns the switching mode in the form x, where:
0 = manual mode,
1 = auto mode
SWM=
SWM?
SWM*
SWM? SWM=x
(see description of
arguments)