Comtech EF Data CRS-500 - Manual (Page 137)

CRS-500 1:N Redundancy System Revision 2
CSU Front Panel Operation MN-CRS500
7–21
7.2.2.4.3.1 UTIL: Firmware
 Info
Firmware Info: Boot
Bulk1 Bulk2
Use the ◄ ► arrow keys to select Boot, Bulk1, or Bulk2, and then press ENTER.
The example that follows shows the information that displays with Bulk1 as the selection:
Bulk1: 09/30/09
FW-0000208 1.1.1
When done, press ENTER or CLEAR to return to the previous menu.
7.2.2.4.3.2 UTIL: Firmware
 Select
Current FW Image: #1
Next Image: Latest #1 #2
This submenu selects which Bulk firmware image the switch will use after the next reboot. The
top line indicates which image is currently selected.
To reboot from a different firmware image: Use the ◄ ► arrow keys to select Latest (i.e., the
firmware with the most current release date), #1, or #2, and then press ENTER.
7.2.2.4.4 UTIL: NTP (Network Time Protocol)
NTP: Primary Secondary
Enable
Use the ◄ ► arrow keys to select Primary, Secondary, or Enable, and then press ENTER.
7.2.2.4.4.1 UTIL: NTP
 Primary / Secondary
NTP Primary Server IP:
192.168.050.001
To edit the NTP Primary or Secondary Server IP Address: On the bottom line, use the ◄ ►
arrow keys to select the digit to edit, and then use the ▲▼ arrow keys to edit the value of that
digit. Press ENTER when done.
7.2.2.4.4.2 UTIL: NTP
 Enable
NTP: Disable Enable
Use the ◄ ► arrow keys to (select) Disable or Enable Network Time Protocol, and then press
ENTER.