AMETEK ASD Series - Manual (Page 93)

Sorensen ASD Series Programming: Digital Interface Control
M551177-01 Rev A 4-35
T EMPERATURE C OEFFICIENTS W INDOW
The Temperature Coefficient window is used for configuring calculated
temperature readings based on the output resistance readback of the
power supply. The calculated temperature readback is also used for load
temperature fault generation. The following equation is used by the
program for calculating the estimated temperature:
0
0
T
alpha
1
) R(T
R
e Temperatur Estimated



P ARAMETER D ESCRIPTION
R(T
0
) The load resistance at reference temperature T
0
T
0
The reference temperature
Alpha The linear temperature coefficient