AMETEK ASD Series - Manual (Page 88)

Programming: Digital Interface Control Sorensen ASD Series
4-30 M551177-01 Rev A
To configure the Ethernet settings:
3. Edit the available fields described as follows:
 IP Address: Input the IP Address of the power supply.
 Port: Should always be set to 502, which is the standard port
for Modbus communications.
 Slave Address: Either leave the value at 0 for an automated
search by the application to find the slave address used by the
power supply, or use the dropdown arrow to set a specific
Modbus slave address for communication with the power
supply.
a. Either:
Click Ok to accept the settings and return to the previous window
or
Click Cancel to return to the previous page without implementing any
changes to the settings
b. Skip to Step 5.