AMETEK ASD Series - Manual (Page 84)

Programming: Digital Interface Control Sorensen ASD Series
4-26 M551177-01 Rev A
4.5.5 SUPERVISORY FAULT CODES
Table 4-17 presents the supervisory fault codes for the Master controller,
and Table 4-18 presents the supervisory fault codes the Modules.
Table 4-17. Master Supervisory Fault Codes
Code Name Description
0x1 SUPERVISORY_I_BIAS Internal circuits OCP
0x10 SUPERVISORY_CAN Issue with internal/external communication bus
0x80 SUPERVISORY_LIN Issue with internal communication bus
0x100 SUPERVISORY_MODBUS_BUFFER_FULL The received Modbus packet is too big
0x200 SUPERVISORY_MODBUS_ERROR
Issue with Modbus communication, usually because
got to many packets
0x400 SUPERVISORY_SPI_ADC_BUSY Communication issue with analog interface ADC.
0x800 SUPERVISORY_ADC_CONFIGURATION Analog interface ADC was not properly configured.
0x1000 SUPERVISORY_MB_MODULE_QUERY_ERROR Issue with the module query Modbus command.
0x2000 SUPERVISORY_FAULT_WATCHDOG Microprocessor watchdog.
0x4000 SUPERVISORY_FLASH_WRITE_ERROR There was an error writing internal Flash memory.
0x8000 SUPERVISORY_COMMAND_ERROR not used
0x10000 SUPERVISORY_FW_UPDATE_NOT_COMPLETE
The firmware update process was not successfully
completed.
0x20000 SUPERVISORY_MASTER_NOT_CALIBRATED
The controller was not calibrated or does not have the
calibration coefficients loaded. It will use default values.
0x40000 SUPERVISORY_FLASH_CSM Problem writing Flash memory because it is locked.
0x80000 SUPERVISORY_REDUNDANT_OUTPUT_ON
One of the redundant output enable circuits may have
a failure.
0x100000 SUPERVISORY_INCORRECT_HARDWARE_VERSION
The hardware version configured in the firmware is not
correct.
0x200000 SUPERVISORY_SPI_ADC_TIMEOUT
The external ADC for the analog interface has not
responded.
0x400000 SUPERVISORY_V_BIAS_5V
The 5V internal supply does not meet the
requirements.
0x800000 SUPERVISORY_V_BIAS_24V
The 24V internal supply does not meet the
requirements.
0x1000000 SUPERVISORY_SWITCH_READ_PROBLEM
the controller reading of the configuration switches is
not reliable
0x2000000 SUPERVISORY_ETHERCAT_FAILED_INIT Only EtherCAT board
0x4000000 SUPERVISORY_WRONG_MASTER_ID
The master ID that was assigned is not compatible with
that firmware or hardware