AMETEK ASD Series User Manual
Page 22

Overview
Sorensen ASD Series
1-24
M551177-01 Rev A
Parameter
Specification
Analog Remote Programming
Voltage Accuracy
0.5% of full-scale
Current Accuracy
1% of full-scale
Power Accuracy
1.5% of full-scale
Voltage Monitoring
0.5% of full-scale
Current Monitoring
1% of full scale
Power Monitoring
1.5% of full-scale
Programming Range
0-10Vdc, 4-20mA
Output Float
Units may be put in series with the float limit of output terminals must
be within ±150V of chassis potential
Parallel
Multiple units can be paralleled to form higher power systems.
Chassis control loops are tied together so that resulting higher power
systems have the same transient response as a 30kW system.
Control commands are only required to be sent to a “master” supply.
Parallel supplies require a shielded CAT 5 cable (STP) and
appropriate output wiring connections by the user.
Calibration
End user calibration is supported. All standard and digital calibration
can be performed without removing covers.
Digital Control (Optional)
1) Ethernet TCP/IP with Modbus-TCP protocol, or
2) RS-485 half-duplex with Modbus-RTU protocol, or
3) Ethernet/IP, or
4) EtherCAT
Analog Control
All control signals are isolated from the outputs.
1.2.3 PHYSICAL CHARACTERISTICS
Dimension
30kW
20kW
10kW
Width
19.00 in (48.3 cm)
19.00 in (48.3 cm)
19.00 in (48.3 cm)
Depth
30.00 in (76.2 cm)
30.00 in (76.2 cm)
30.00 in (76.2 cm)
Height
5.22 in (13.25 cm) rack mount
5.22 in (13.25 cm) rack mount 5.22 in (13.25 cm) rack mount
Weight
125 lbs (56.69 kg)