AMETEK ASD Series - Manual (Page 23)

M551177-01 Rev A 2-25
SECTION 2
INSTALLATION
2.1 INSPECTION
Inspect the shipping carton for possible damage before unpacking the unit.
Carefully unpack the equipment. Save all packing materials until
inspection is complete. Verify that all items listed on the packing slips have
been received. Visually inspect all exterior surfaces for broken knobs,
connectors, or meters. Inspect for dented or damaged exterior surfaces.
External damage may be an indication of internal damage. If any damage
is evident, immediately contact the carrier that delivered the unit and
submit a damage report. Failure to do so could invalidate future claims.
Direct repair issues to Customer Service at 858-458-0223 (local) or 1-800-
733-5427(toll free).
2.2 CONTENTS OF SHIPMENT
Depending on the model, configuration, and options available for your
ASD Series power supply, the ship kit may include additional parts and
accessories. At a minimum, the ship kit that accompanies your ASD
Series power supply includes the following items:

ASD Series DC Power Supplies Operation and programming
Manual (Part No. M551177-01)

Sense mating connector (Molex P/N 39-01-4031) with loose
contacts (Molex P/N 39-00-0182)
 J1 mating connector (Cinch P/N DB25P or equivalent) normally
shipped attached to rear panel J1

Back shell for J1 (DB25) mating connector (Amphenol P/N
17E17262 and CINCH P/N DB19678-7)

Modular terminator (Ametek P/N 5551009-01)
 Water pipe plugs (Caplug P/N P-38B)
 Bolt, lock washer, and nut for output power connections:
 If bus bars installed in unit, four each: 3/8- 16 x 1.00” brass screw,
3/8 flat brass washer, and 3/8 split lock brass washer.