Figure 55. select linker command file dialog box – Zilog ZUSBOPTS User Manual
Page 91
UM017105-0511
Menu Bar
Zilog Developer Studio II – ZNEO™
User Manual
63
visual indication to remind you that some of your project settings might not be fully taking
effect on later builds. If you need to create a complex linker command file, contact Zilog
Technical Support for assistance. See
If you have selected the
Additional Directives
checkbox, your manually inserted direc-
tives are not erased when you build your project. They are retained and re-inserted into the
same location in each newly created linker command file every time you build your proj-
ect.
In earlier releases of ZDS II, it was necessary to manually insert a number of directives if
you had a C project and did not select the Standard C Start-up Module. This is no longer
necessary. The directives required to support a C start-up module are now always added to
the linker command file. The only time these directives are not added is if the project is an
Assembly Only project.
Use Existing.
Observe the following procedure if you do not want a new linker command
file to be generated when you build your project:
1. Select the
Use Existing
button.
2. Click the
Browse
button (
). The
Select Linker Command File
dialog box is dis-
played; see Figure 55.
3. Use the
Look In
drop-down menu to navigate to the linker command file that you
want to use.
Figure 55. Select Linker Command File Dialog Box
Note: