Zilog ZUSBOPTS - Manual (Page 416)

Running the Flash Loader from the Command Processor UM017105-0511
388
Zilog Developer Studio II – ZNEO™
User Manual
Executing Flash Commands
The Flash Loader dialog box and the Command Processor interface use the same
parameters. If an option is not specified with the Command Processor interface,
the current setting in the Flash Loader dialog box is used. If a setting is changed
in the Command Processor interface, the Flash Loader dialog box settings are
changed.
Examples
The following are valid examples:
FLASH Options INTMEM
Flash Options ISN Include a serial number
Flash Options NPBF Do not page-erase Flash mem-
ory; use mass erase
Flash Options PBF Page-erase Flash memory
Flash Options SERIALADDRESS = "<address>" Serial number address
Flash Options SERIALNUMBER = "<Number in Hex>" Initial serial number value
Flash Options SERIALSIZE = <1-8> Number of bytes in serial number
Flash Options INCREMENT = "<Decimal value>" Increment value for serial num-
ber
Flash READSERIAL Read the serial number
Flash READSERIAL REPEAT Read the serial number and repeat
Flash BURNSERIAL Program the serial number
Flash BURNSERIAL REPEAT Program the serial number and repeat
Flash ERASE Erase Flash memory
Flash ERASE REPEAT Erase Flash memory and repeat
Flash BURN Program Flash memory
Flash BURN REPEAT Program Flash memory and repeat
Flash BURNVERIFY Program and verify Flash memory
Flash BURNVERIFY REPEAT Program and verify Flash memory and repeat
Flash VERIFY Verify Flash memory
Flash VERIFY REPEAT Verify Flash memory and repeat
Caution: