Firmware upgrade, Show crc – Zilog ZUSBOPTS User Manual
Page 119
UM017105-0511
Menu Bar
Zilog Developer Studio II – ZNEO™
User Manual
91
d. Click
Read Serial
to check the serial number for the current device.
17. Program the Flash memory by clicking one of the following buttons:
–
Click
Program
to write the hex file to Flash memory and perform no checking
while writing.
–
Click
Program and Verify
to write the hex file to Flash memory by writing a seg-
ment of data and then reading back the segment and verifying that it has been
written correctly.
18. Click
Verify
to verify Flash memory. The Flash Loader reads and compares the hex
file contents with the current contents of Flash memory. This function does not change
target Flash memory.
Firmware Upgrade
This command is available only when a supporting debug tool is selected (see the
•
USB Smart Cable
<ZDS Installation Directory>
\bin\firmware\USBSmartCable\USBSmartCa-
ble upgrade information.txt
•
Serial Smart Cable
This product is not available for this release.
•
Ethernet Smart Cable
<ZDS Installation Directory>
\bin\firmware\EthernetSmartCable\Ether-
netSmartCable upgrade information.txt
Show CRC
This command is only available when the target is not a simulator.
Observe the following procedure to perform a cyclic redundancy check (CRC):
1. Select
Show CRC
from the
Tools
menu. The
Show CRC
dialog box is displayed; see
Note:
Note: