Zilog ZUSBOPTS - Manual (Page 47)

UM017105-0511 Toolbars
Zilog Developer Studio II – ZNEO™
User Manual
19
Insert/Remove Breakpoint Button. The Insert/Remove Breakpoint button sets a new
breakpoint or removes an existing breakpoint in the active file at the line in which the cur-
sor is. You can set a breakpoint in any line with a blue dot displayed to the left of the line
(shown in Debug mode only).
Enable/Disable Breakpoint Button. The Enable/Disable Breakpoint button activates or
deactivates an existing breakpoint at the line in which the cursor is. A red octagon indi-
cates an enabled breakpoint; a white octagon indicates a disabled breakpoint.
Remove All Breakpoints Button. The Remove All Breakpoints button deletes all
breakpoints in the currently loaded project.
Find Toolbar
The Find toolbar, shown in Figure 17, provides access to text search functions using either
of two entry points, each of which is briefly described below.
Find in Files Button. Opens the Find in Files dialog box, allowing you to search for text
in multiple files.
Find Field. To locate text in the active file, enter the text in the Find field and press the
Enter key. The search term is highlighted in the file. To search again, press the Enter key
again.
Command Processor Toolbar
The Command Processor toolbar, shown in Figure 18, allows you to execute IDE and
debugger commands using either of two entry points, each of which is briefly described
below.
See Supported Script File Commands on page 364 for a list of supported commands.
Figure 17. The Find Toolbar
Figure 18. The Command Processor Toolbar