Zilog ZUSBOPTS - Manual (Page 71)

UM017105-0511 Menu Bar
Zilog Developer Studio II – ZNEO™
User Manual
43
8. Click Find Next to jump to the next occurrence of the search text, click Replace to
replace the highlighted text, or click Replace All to automatically replace all instances
of the search text.
Go to Line. To position the cursor at a specific line in the active file, select Go to Line
from the Edit menu to display the Go to Line Number dialog box, as shown in Figure 44.
Enter the desired line number in the edit field and click Go To .
Manage Breakpoints
To view, go to, enable, disable, or remove breakpoints in an active project, select Manage
Breakpoints from the Edit menu. You can access the Breakpoints dialog box, shown in
Figure 45, during Debug mode and Edit mode.
The Breakpoints dialog box lists all existing breakpoints for the currently loaded project.
A check mark in the box to the left of the breakpoint description indicates that the break-
point is enabled. Each of the buttons in this dialog box is described in this section.
Go to Code. To move the cursor to a particular breakpoint you have set in a file, highlight
the breakpoint in the Breakpoints dialog box and click Go to Code .
Enable All. To make all listed breakpoints active, click Enable All . Individual breakpoints
can be enabled by clicking in the box to the left of the breakpoint description. Enabled
Figure 44. Go to Line Number Dialog Box
Figure 45. Breakpoints Dialog Box