Zilog ZUSBOPTS User Manual
Page 118
Menu Bar
UM017105-0511
90
Zilog Developer Studio II – ZNEO™
User Manual
12. Enter the appropriate offset values in the
File Offset
field to offset the base address of
the hex file. The hex file address is shifted by the offset defined in the
Start Address
area; however, you must allow for the shift in any defined jump table index. This off-
set value also shifts the erase range for the Flash.
13. Select the
Erase Before Flashing
checkbox to erase all Flash memory before writing
the hex file to Flash memory.
Be careful when selecting pages from which to delete Flash memory. Clicking
ERASE
deletes only the pages that are selected.
14. If appropriate, select the
Close Dialog When Complete
checkbox to close the dialog
box after writing the hex file to Flash memory.
15. To use the serialization feature, observe the following procedure.
a.
Select the
Include Serial in Programming
checkbox. This option programs the
serial number after the selected hex file has been written to Flash.
b. Select the
Enable
checkbox.
c.
Enter the start value for the serial number in the
Serial Value
field and select the
Dec
button for a decimal serial number or the
Hex
button for a hexadecimal serial
number.
d. Enter the location in which you want the serial number to be located in the
Address Hex
field.
e.
Select the number of bytes that you want the serial number to occupy in the
#
Bytes
drop-down menu.
f.
Enter the decimal interval that you want the serial number incremented by in the
Increment Dec
(+/–) field. If you want the serial number to be decremented, enter
a negative number. After the current serial number is programmed, the serial num-
ber is then incremented or decremented by the amount in the Increment Dec (+/–)
field.
g. Select the
Erase Before Flashing
checkbox. This option erases the Flash before
writing the serial number.
h. Click
Burn Serial
to write the serial number to the current device or click
Pro-
gram
or
Program and Verify
to program the Flash memory with the specified
hex file and write the serial number.
16. If you want to check a serial number that has already been programmed at an address,
perform the following brief procedure.
a.
Select the
Enable
checkbox.
b. Enter the address that you want to read in the
Address Hex
field.
c.
Select the number of bytes to read from
# Bytes
drop-down menu.
Caution: