Zilog ZUSBOPTS - Manual (Page 104)

Menu Bar UM017105-0511
76
Zilog Developer Studio II – ZNEO™
User Manual
Target. Select the appropriate target from the Target list box.
Setup. Click Setup in the Target area to display the Configure Target dialog box; see
Figure 61.
The options displayed in the Configure Target dialog box depend on the CPU you selected
in the New Project dialog box (see the New Project section on page 32) or the General
page of the Project Settings dialog box (see the Project Settings—General Page section
on page 47). Chip select and external bus interface settings are only available for CPUs that
support an external bus.
1. Select an 8-bit, 16-bit, or no external bus interface. Selecting an external bus interface
is appropriate only for target designs that use an external bus.
2. If an external bus interface is selected, do the following steps for each chip select that
is used by the target system for external memory or I/O. The settings appropriate for
each chip select depend on the target system design.
a. Choose the chip select register (CS0–CS5) from the Chip Select Registers drop-
down menu.
b. Select the Enabled checkbox to enable the chip select. Do not enable chip selects
that the target does not use.
Figure 61. Configure Target Dialog Box
Note: