Zilog ZUSBOPTS - Manual (Page 29)

UM017105-0511 Getting Started
Zilog Developer Studio II – ZNEO™
User Manual
1
Chapter 1. Getting Started
This section provides a tutorial of the developer’s environment, so you can be working
with the ZDS II graphical user interface (GUI) in a short time. This section covers the fol-
lowing topics:
•
Installing ZDS II on page 1
•
Developer’s Environment Tutorial on page 1

You can use this tutorial to install and start using ZDS II without any attached hardware. If
you have a development kit, use the included Quick Start Guide to set up your hardware
and install ZDS II. For steps to create a new project using target hardware, see
New Project
on page 32.
Installing ZDS II
If you have not already installed ZDS II, perform the following procedure:
1. Insert the CD in your CD-ROM drive.
2. Follow the setup instructions on your screen.
3. Install the application in an appropriate folder location on your PC.
Developer’s Environment Tutorial
This tutorial shows you how to use the basic features of Zilog Developer Studio. To begin
this tour, you need a basic understanding of Microsoft Windows. Estimated time for com-
pleting this exercise is 15 minutes.
In this tour, you perform the following brief procedure.
•
Create a New Project on page 2
•
Add a File to the Project on page 6
•
Set Up the Project on page 8

When you complete this tour and save your project, you will have a sample.lod file that
can be used for debugging.
Note: