Figure 71. flash loader processor dialog box – Zilog ZUSBOPTS User Manual
Page 116
Menu Bar
UM017105-0511
88
Zilog Developer Studio II – ZNEO™
User Manual
a.
If external memory is used on the target, ensure that the appropriate external bus
interface is selected and that each chip select register used on the target is enabled
and configured properly.
b. Configure the
Clock Source
and
Frequency
settings to match the clock source
and frequency used on the target.
3. In the
Address Spaces
page (see page 68), configure the address range for each type
of memory that is present on the target.
4. Select
Flash Loader
from the
Tools
menu. The Flash Loader connects to the target
and sets up communication. The
Flash Loader Processor
dialog box is displayed
(see Figure 71) with the appropriate Flash target options for the selected CPU.
5. Click the
Browse
button (
) to navigate to the hex file to be flashed.
6. Select the Flash targets in the
Flash Options
area. The Flash Options are displayed in
the
Flash Loader Processor
dialog box depend on the CPU you selected in the
Gen-
Figure 71. Flash Loader Processor Dialog Box