Moving to a breakpoint, Enabling breakpoints, Moving to a breakpoint enabling breakpoints – Zilog ZUSBOPTS User Manual
Page 373: Viewing breakpoints
UM017105-0511
Using Breakpoints
Zilog Developer Studio II – ZNEO™
User Manual
345
You can use the
Breakpoints
dialog box to view, go to, enable, disable, or remove break-
points in an active project when in or out of Debug mode.
Moving to a Breakpoint
To quickly move the cursor to a breakpoint you have previously set in your project, per-
form the following brief procedure.
1. Select
Manage Breakpoints
from the
Edit
menu. The
Breakpoints
dialog box is dis-
played.
2. Highlight the breakpoint you want.
3. Click
Go to Code
. Your cursor moves to the line in which the breakpoint is set.
Enabling Breakpoints
To make all breakpoints in a project active, perform the following brief procedure.
1. Select
Manage Breakpoints
from the
Edit
menu.The
Breakpoints
dialog box is dis-
played.
2. Click
Enable All
. Check marks are displayed to the left of all enabled breakpoints.
3. Click
OK
.
There are three ways to enable one breakpoint:
•
Double-click the white octagon to remove the breakpoint and then double-click where
the octagon was to enable the breakpoint
Figure 155. Viewing Breakpoints