Datapath Wall Control - Manual (Page 93)

Vision Carousel Settings
The Carousel Settings sheet allows you to define a number of inputs which the window will cycle through allowing you to view
each in turn. The inputs to be used are defined by creating a Display List. Each entry in the list can be viewed for a specified
duration and with different cropping rectangle. Once a Carousel Display List has been created, starting the Carousel causes
the Vision window to automatically cycle through the list of inputs.
To configure the Carousel properties for a Vision window, right click on the active window and select Carousel Properties and
the following dialogue is displayed:
When the Carousel Settings dialogue is displayed, the Vision window is disabled, preventing other users from modifying or
closing it.
The Carousel Settings dialogue has the following groups:
Input Selection
Cropping
Carousel Display List
Input Selection
Using the Input drop down menu, select the required input source. Its display time may be adjusted in one second intervals
using the Duration time control. The minimum display time is one second and the maximum is one day. The default setting is
one minute.
Cropping
The cropping controls allow you to select a rectangular region from the input signal to be displayed in the OEM_VISION_TAG
window. The
Top and Left controls specify the position of the cropping rectangle relative to the top-left corner of the input
signal. The Width and Height controls specify the size of the cropping rectangle. The On radio button must be selected for
these values to be implemented. Selecting Off will ignore the cropping rectangle and display the raw input signal.
If the source is VGA, the Overscan radio button can be selected. Overscan automatically configures the best cropping values
for displaying the full input signal.
93 / 155