Datapath Wall Control User Manual
Page 117
Camera Name
Type the camera name into the Camera Name edit box. The name can be up to 31 characters long with no leading or trailing
spaces and must be unique with respect to all other camera names.
Camera Model
Use the camera model drop down list to select the model of the camera that is being configured. This list will contain a number
of pre-configured models along with any additional user configured models that have been added to the system.
Camera Authorisation
Use the camera authorisation controls to override the camera model’s default settings.
IP Address / Host Name
Use the IP address or host name edit box to set the camera’s network address. This field may also contain a port number
separated by the ‘:’ character (ex. 10.0.0.2:7071). If this edit box is left blank then a warning prompt will be displayed when the
OK
button is pressed.
Once the camera configuration is complete press the
OK
button to create the camera and close the dialogue.
Note:
IP-Camera connectivity is not validated at the point at which a camera is configured. Therefore, the successful
configuration of a camera does not guarantee that the camera in question will operate as expected in Wall Control-
red.
Modifying and Removing Existing IP-Cameras
117 / 155