Datapath Wall Control - Manual (Page 154)

dialogue or Wall Control-red has not been activated, the problem is with the port name.
If networking is enabled, the problem could be with either the port number or the port name.
You can find out the port number and the port name that the server application is using through the Server Application Manager
dialogue or the application event viewer .
You can find out which port numbers are in use on a machine with the netstat command. There is no way to find out which port
names are in use.
Use the Server Application Manager to change the port number and/or port name and restart the server application.
The remote procedure call failed and did not execute
This is displayed when trying to contact a server application that has been stopped after it had been connected to successfully.
Go to the
Server Application Manager dialogue and start the server application again.
Changing Screen Resolution
Prior to making any changes to the resolution, it is recommended that the Vision server be stopped beforehand. This can be
done using the
Server Application Manager dialogue.
The servers retain resources on the graphics card which my not be available if the resolution is changed.
154 / 155