Datapath Wall Control - Manual (Page 104)

Select Show dialogue to display the Disconnect dialogue.
Select Always close windows to close all windows that Wall Control-red manages.
Select Never close windows to leave open all windows that Wall Control-red manages.
Display of Video/Data Wall
The Wall Control-red application can be configured to display a capture of the desktop within the application window.
Select Wire frame to display a wire frame representation in the Wall Control-red application window.
Select Capture desktop and the desktop is displayed in the Wall Control-red application window. The captured desktop is
refreshed approximately every second. Capturing the desktop will use up more system resources than the wire frame display.
Show gaps enables you to display any desktop gaps you have created on the captured desktop. This function is only available
when Capture desktop is selected.
Display of Control Screen
A non-Datapath graphics card such as an on board graphics adapter can be used as a Control Screen for the Wall Control-red
application. If this method is used a representation of the Control Screen is displayed in the Wall Control-red application.
Display of Control Screen enables you to configure how the control screen is displayed in the Wall Control-red application
window.
Select Don’t show and the Control Screen representation is removed from the Wall Control-red application window.
Select Wire frame to display a wire frame representation in the Wall Control-red application window.
Select Capture desktop and the desktop of the Control Screen is captured and displayed in the Wall Control-red application
window.
Alerts - Wire Frame Only
If it is not possible to display a Vision input, the area where the window is displayed in Wall Control-red can be made to flash.
The reasons why a source cannot be displayed fall into two categories: no signal and error.
If no signal is detected the source has been disconnected or switched off.
If an error has occurred, one of the following has happened:
The signal is beyond the capabilities of the hardware.
There are no hardware resources available to display the signal.
An error has occurred within the system.
You can switch the flashing of the windows on or off and change the text that appears when the input cannot be displayed.
Language Select
Use the dropdown arrow to select the required display language.
104 / 155