Datapath Wall Control User Manual
Page 116
The Render Station was successfully connected and is ready for use.
Error
The Render Station was previously connected without any errors but is now not responding. It will revert to a connected state
once the connection is restored.
Reboot
The
Reboot
button allows the user to remotely reboot a connected Render Station. It can also be used to reset the connection
to a station that is in an error state. This is intended as an administrative tool and should only be used under the direction of
support staff.
Configuring Cameras
By default Wall Control-red does not have any cameras configured. The user may add cameras by clicking the
Add
button on
the right side of the dialogue.
Adding New IP-Cameras
Click on the
Add
button and the following dialogue is displayed.
116 / 155