Datapath Wall Control - Manual (Page 77)

Colour Balance
The Colour Balance dialogue allows you to change the colour balance for an input connector.
All controls in this dialogue box are interactive so the changes you make will be seen when the next frame of data is displayed
in the Vision window.
All Colours
The Brightness and Contrast controls alter the settings for all colours. These are the same as the Brightness and Contrast
controls in the Vision Input Settings sheet.
Red
The red controls allow the brightness and contrast of the red part of the Vision signal to be adjusted a small amount relative to
the over all brightness and contrast settings.
Green
The green controls allow the brightness and contrast of the green part of the Vision signal to be adjusted a small amount
relative to the over all brightness and contrast settings.
Blue
The blue controls allow the brightness and contrast of the blue part of the Vision signal to be adjusted a small amount relative to
the over all brightness and contrast settings.
Reset
The Reset button will set all the values to the default settings.
77 / 155