Datapath Wall Control - Manual (Page 119)

The selected Render Station is offline.
Configure Camera Models
By default Wall Control-red supports a number of pre-configured IP-Cameras. The Camera Models configuration dialogue
allows additional camera models to be defined that should work with other IP-Cameras, including those from different
manufacturers.
The Camera Models tab has three buttons located to the right of the model names. The status and names of these buttons will
change depending on which, if any, of the models are selected and also on the current Wall Control-red license. Camera
Models can be added providing a red dongle is inserted into the machine. The middle button is entitled “View” when one of the
pre-configured models is selected. These models are read only and cannot be modified or removed. However, when a model is
selected that has been added to Wall Control-red (via the add button) then this middle button is entitled “Modify”. This button
can then be selected to make changes to the model in question.
Click on the Add or Modify/View buttons to display the IP-Camera Model dialogue (shown below). The controls in this dialogue
are read only if a pre-configured model is being modified.
119 / 155