Datapath Wall Control - Manual (Page 115)

Render Stations as required.
When the Render Stations are configured and OK is pressed on the Configure dialogue, Wall Control-red will connect to the
Render Stations. When the Render Stations are connected Vision inputs assigned to Render Stations will become unavailable
to the Vision application.
A configured Render Station screen can be deleted by selecting its entry from the list in the Configure dialogue and pressing
the Remove button. To completely remove a Render Station both Screen A and Screen B must be removed.
The IP Address of a Render Station assigned to a VisionRGB-E2 input can be changed by selecting the entry from the list and
clicking the Modify button. The VisionRGB-E2 input cannot be changed from the Modify dialogue, and a new entry must be
created instead.
Render Station Status
The status column indicates the connection status for each configured Render Station screen. The five possible states are as
follows:
Testing
Wall Control is in the process of testing all connections.
Offline
The Render Station has not been connected. All stations are shown as offline until they can be connected. It may take up to
twenty seconds for the status to change to the connected state.
Flash Error
The Render Station was successfully connected but the Vision card's EDID could not be flashed. This may be caused by a
hardware issue or the use of an incorrect driver. When in this state the capabilities may be reduced.
Screen Error
The Render Station was successfully connected but an initialisation error occurred. This may be caused by an incorrect
software or hardware configuration on the Render Station. When in this state the capabilities may be reduced.
Connected
115 / 155