Datapath Wall Control - Manual (Page 108)

Vision
When Vision is selected, the following dialogue is displayed.
Use the Configure Vision dialogue to set up the labels for the Vision inputs.
Click on
Add… to create a new label and the following dialogue is displayed:
Input Labels
Click
Add to create a new label and the following dialogue is displayed:
Type the label in the
Label edit box. The label can be up to 31 characters long with no leading or trailing spaces. Only one label
can be created for each Vision input.
Use the up / down arrows to select an input.
Click on OK and the label will be added to the list of Input Labels in the Configure Vision dialogue box.
The label will also be displayed in the list of available Vision Sources on the Input Settings sheet.
Window Text
Use the Window Text controls to amend the text display in a Vision window when 'No Signal' or 'Invalid Signal' is detected on
the input.
EDID
108 / 155