BINDER CB 60 - Manual (Page 66)

CB (E6) 09/2013 Page 66/144
Fixed value 08.03.2013 05:05:06
Submenu “Network settings” (next page).
..\ Network settings
DNS2
Close Home
Show network settings Overview of the entire network configuration
DHCP On/Off Switching on and off the DHCP state
IP address Entering the desired IP address
Subnet mask Entering the subnet mask number
Chamber name Entering the name of the CO
2
incubator
Network name Entering the network name
Gateway Entering the gateway number
DNS1 Entering the DNS1 number
DNS2 Entering the DNS2 number
Set the DHCP State on/off:
Fixed value 22.08.2012 05:05:06
Submenu “DHCP On/Off”.
The current DHCP state is displayed. Press the
operating button to change it.
Then the new DHCP state is displayed
“DHCP : On” = DHCP state activated
“DHCP : Off” = DHCP state deactivated
..\ DHCP On/Off
DHCP : On
Close Home
Go back to the “Network settings” menu with “Close” or to the initial view with “Home”.
You can only configure the following network settings if the DHCP state is set to “Off”.