Xerox 7024 - Manual (Page 95)

RECEIVING
2. Press [6] two times on the second telephone to switch the call
to the terminal. When you hear the fax tones, hang up the
handset. The receive operation will begin.
RECEIVE STD
Note: if you press any key on the control panel of the terminal
before pressing 6 two times, you cannot perform the remote
receive operation.
The second telephone may not switch to the terminal depending
on the situation of the telephone line or the type of second
telephone you have.
To automatically receive a document using LOAD
ORIG: (TEL) answer mode
When you have selected the LOAD ORIG: (TEL) mode and allow
the terminal to answer incoming calls automatically, callers to
your terminal will hear a recorded message:
Hello. If you wish to send a fax, transmit now. If not, check the
number and dial again. Thank you.
If your terminal detects fax tones, the recorded message will not
be played and the terminal will receive the incoming document.
While the message Is being delivered, the handset on the
terminal will ring softly, letting you know your terminal has
answered the telephone line but has not yet attempted
reception. You can pick up the handset at any time during the
10-second message to turn off the voice message and listen to
the incoming call through the handset.
1. Remove any documents from the ADF and press [Manual
Receive] until the following displays:
LOAD ORIG: (TEL)
SEP 30'91 10:55
2. When your telephone rings, you can allow your terminal to
answer automatically and receive the document;
INCOMING CALL
or you can answer the call manually for voice
communication. If you hear fax tones, press [Start] and hang
up the handset to begin the receive operation.
RECEIVE STD
3. The terminal will receive and print the incoming document.
COMPLETED
TELECOPIER 7024 USER HANDBOOK 5-3