Xerox 7024 - Manual (Page 52)

DIALLING
To set program one touch keys (P1-P6) for multi-step
operations (Menu 10, Feature 2)
Program one touch keys, P1-P6, can also be programmed for
multi-step operations. These multi-step operations can be
reduced to a single keystroke. Use the following procedure to
program a P1-P6 key. If the key is programmed for one touch
and program one touch, the number stored can be used for two
different operations.
The following six features can be programmed into the one
touch keys P1-P6:
Delayed Send, Group Send/Delayed Group
Send, Relay Send, Send Secure Mail, Polling/Delayed Polling and
Multi-polling.
For example, to transmit reports to several locations everyday,
program a P1-P6 keys for group send/delayed group send to
those locations. The terminal will send to each location with one
keystroke immediately or at the hour selected. The operation
will take place within twenty four hours.
The current settings of Forced 4800, Secure Send mode and Long
Original are automatically stored with the program. The settings
of these features should be considered and changed, if desired,
as you program the P1-P6 keys.
The first 7 steps to program the one touch P1-P6 keys are the
same regardless of the feature you select. The remaining steps
vary based on the feature you have chosen. The first 7 steps
appear below. Steps 8 and beyond for each feature appear on
the following pages under the appropriate name.
1. Press [Menu] to select the menu table.
l.SEND OPTIONSl
01-10 SELECT/ENTER
2. Press [1]. [0], [Enter] to select the feature.
1.ENTER ONE-TOUCH
1-2
SELECT/ENTER
3. Press [2] to select PROGRAM ONE-TOUCH.
2.PROGRAM ONE-TOUCH
1-2 SELECT/ENTER
4. Press [Enter].
PROGRAM KEY PI TO P6
SELECT AND PRESS
2-10 TELECOPIER 7024 USER HANDBOOK