Xerox 7024 - Manual (Page 36)

PREPARING THE MACHINE FOR OPERATION
Set answering machine
When you connect a telephone answering machine (TAD) to
your terminal, the guidelines listed below should be followed:^
• Answering machine device: The rings before answer setting
on your answering machine should be set to answer before 7
rings. The terminal will automatically answer the call after 7
rings.
• Jack connection and Set answering machine: The jack
connection of the answering machine and the settings of the
set answering machine feature below should match. The
recommended connection and setting is TEL2.
• Answer mode: The answer mode should be set to LOAD
ORIG: (ANS).
• SET TAD TIME: User specified (see next page.)
To set answering machine (Menu 09, Feature 11)
TEL1
TEL2
This setting is used when you connect an answering
machine to the TEL1 jack. (See footnote)
This setting is used when you connea an answering
machine to the TEL2 jack.
1. Press [Menu] to select the menu table.
l.SEND OPTIONSl
01-10 SELECT/ENTER
2. Press [0], (9] to select menu 9.
9.USER SETTINGS
01-10
SELECT/ENTER
3. Press (Enter] to select the first feature within the menu.
l.SET POLLED MODE
01-21 SELECT/ENTER
4. Press [1], [1] to select SET ANS. MACHINE.
11.SET ANS. MACHINE
01-21 SELECT/ENTER
1. There are two jack selections on your terminal. If desired, the answering machine can be connected to the
TEL1 jack and the handset to the TEL2 jack.
1-16 TELECOPIER 7024 USER HANDBOOK