Installing the customer assistance label, Installing the power cord – Xerox 7024 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

INSTAUATiON

Installing the customer assistance label

Record the serial number on the customer assistance label

and in the User Handbook, Section 8, Requesting assistance.
The serial numt>er is located under the printer cover to the
left of the imaging cartridge.

Record the customer support center telephone number on

the customer assistance label. The number is in the User

Handbook, Section 8, Requesting assistance.

Remove the cover backing from the customer assistance label

and place the label on the right rear corner of the terminal.

Installing the power cord

1. Make sure the power switch at the right side of the terminal

is off.

2. Plug one end of the power cord into the connector at the

rear of the term i nal.

3. Plug the other end of the power cord into the wall outlet.

4. Turn the power switch on.

Note: Do not install the terminal on the same electrical circuit
as an air conditioner, copier machine or other high consumption
electrical appliance. These appliances can cause electrical "draw
downs” when they operate-temporarily reducing the power
available for other equipment on the circuit-and could damage

your terminal.

xviii

TELECOPIER 7024 USER HANDBOOK