Set ecm (error correction mode), To set ecm mode (menu 09, feature 15), Set ecm (error correction mode) -5 – Xerox 7024 User Manual
Page 123: To set ecm mode (menu 09, feature 15) -5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CUSTOM FEATURES AND SETTINGS
Set ECM (Error correction mode)
Your terminal offers an error correction mode for transmissions
and receptions. The remote terminal must also support this
feature. The terminal sends your document in high speed
segments. After each segment is sent, the terminal waits briefly
to receive a signal from the remote unit confirming the segment
of image data was received properly. If confirmation is not
received, the terminal will retransmit the segment. Using ECM
reception, your terminal responds after each segment is
received, indicating whether the segment should be sent again
or was received error free. The default for this feature is ON.
To set ECM mode (Menu 09, Feature 15)
1. Press [Menu] to select the menu table.
l.SEND OPTIONSl
01-10
SELECT/ENTER
2. Press [0], [9] to select menu 9.
9.USER
SETTINGS
01-10
SELECT/ENTER
3. Press [Enter] to select the first feature within the menu.
l.SET POLLED MODE
01-21
SELECT/ENTER
4. Press [1 ], [5] to select SET ECM MODE.
15.SET ECM MODE
01-21
SELECT/ENTER
5. Press [Enter].
B
ECM MODE:
ON
SELECT/ENTER
6. Press [Select] to select ON or OFF.
ECM MODE :
ON
SELECT/ENTER
ECM MODE:
OFF
SELECT/ENTER
7. Press [Enter] to record desired setting.
SET ECM MODE
COMPLETED
TELECOPIER 7024 USER HANDBOOK
7-5