Memory, Receive to memory, Memory -21 – Xerox 7024 User Manual
Page 41: Receive to memory -21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Memory
PREPARING THE MACHINE FOR OPERATION
If scan to memory is selected in the feature, the terminal will not
transmit the originals as it scans them, but stores the image,
telephone number, and other data as a stored job in memory.
The originals, therefore, do not block the document tray while
the terminal is waiting to transmit the images - an advantage
that is important when you request transmission after hours,
when telephone rates are lower.
The terminal has a memory capacity equivalent to approximately
sixteen standard size pages for transmission at normal resolution
with ECM turned off. The terminal will store approximately
twelve pages with ECM turned on. Actual memory requirements
vary with such factors as document size, contents and resolution.
The following features can be stored in memory;
•
Delayed send
•
Delayed group send
•
Relay send
•
Secure send
•
Store for polling
Receive to memory
The terminal automatically receives and stores documents into
memory when the terminal is out of supplies or when a paper
jam occurs.The following displays during the receive operation
if ECM mode is set to OFF:
RECEIVE
MEMORY
STD
The following displays during the receive operation if ECM is set
to ON;
RECEIVE
ECM
STD
The documents will print out from memory after the supplies
have been replaced or the paper jam is cleared.
Memory available
When the terminal is in the idle mode, press [Select] to display
the number of pending jobs and the total percentage of memory
used.
1. Remove originals from ADF. Press [Select] to display the
number of pending jobs.
PENDING JOBS
(01)
1, Under certain conditions, the document will first be received to memory and printed automatically.
TELECOPIER 7024 USER HANDBOOK
1-21