Us: xerox data coupler information, Us: xerox data coupler information -2 – Xerox 7024 User Manual
Page 154
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

REFERENCE
US: Xerox data coupler information
This Xerox Telecopier 7024 facsimile terminal contains an
internal data coupler. Its use is restricted by the FCC (Federal
Communications Commission). To comply with the FCC rules,
you must carefully read and follow the instructions listed
below:
This equipment complies with Part 68 of the FCC rules. On
the rear of this equipment is a label that contains, among
other information, the FCC registration number and Ringer
Equivalence Number (REN). If requested, provide this
information to your telephone company.
The REN is useful to determine the quantity of devices you
may connect to your telephone line and still have all of those
devices ring when your number is called. In most, but not all
areas, the sum of the RENs of all devices should not exceed
five (5.0). To be certain of the number of devices you may
connect to your line, as determined by the REN, you should
call your local telephone company to determine the
maximum REN for your calling area.
Warning:
Ask your local telephone company for the
modular jack type installed on your line. Connecting this
terminal to an unauthorized jack can severely damage
telephone company equipment. You, not Xerox, assume all
responsibility and/or liability for any damage caused by the
connection of this terminal to an unauthorized jack.
You may safely connect the terminal to the following
standard modular jack: USOC RJ-11C. Use the standard line
cord (with modular plugs) provided with the installation kit
to connect it.
Do not connect this terminal to a party or coin operated
phone line.
Repairs to the terminal should only be made by Xerox or an
authorized Xerox service agency. This applies at any time
during or after the service warranty period. If unauthorized
repair is performed, the remainder of the warranty period is
null and void.
If you find the telephone line is damaged or the telephone
company notifies you that your terminal is causing damage,
disconnect the terminal from the telephone line and call for
service. Do not reconnect the terminal until necessary repairs
are made.
The telephone company will, where practical, notify you
when they need to temporarily disconnect service. However,
if action is reasonable and necessary, but prior notice is not
practical, they may still temporarily disconnect your service.
In such cases they must:
• Immediately notify you of their temporary action.
• Reconnect service when the source of damage is removed.
• Inform you of your rights to bring a complaint to the FCC
under FCC rules.
Q.7
TELECOPIER 7024 USER HANDBOOK