EVCO c-pro CLIMA sistema Installer manual - Manual (Page 63)

C-PRO CLIMA SISTEMA INSTALLER MANUAL
Page 63
8.4.7 Installer menu
The installer menu is level 2, i.e. used to insert the installer level password or higher in order to
display/modify the parameters present in this branch.
From this menu it is possible to view and set the configuration of the DHW system, the solar panels
system/s and the auxiliary system and their controls.
Entering the I/O CONFIGURATION menu it is possible to view the type of analogue inputs set in
the application and set the polarity of the digital inputs used.
Entering the GENERAL PARAMETERS menu, it is possible to define the main features present in
the regulator for solar panels, i.e. the name of the MCPS regulator, the number of solar panel
circuits present in the system, the presence or not of the auxiliary circuit, the number of temperature
probes present in the DHW tank, the type of digital inputs for protection of the circulation pumps
and the features of the serial communication parameters both CANbus (c-pro CLIMA controllers
network) and Modbus (towards the RICS supervision system or other BMS systems).
Entering the SOLAR PANELS menu it is possible to set the calibration of the solar panels
temperature transducers, also defining their minimum and maximum calibration values.
Finally the PASSWORDS menu allows to display and modify the 3 password levels present in the
application.
8.5 System Network page
Accessing the System Network page of the MCPS regulator, it is possible to go back to the MCCT
thermal power plant application as follows:
By pressing ESC key, the controller will go back all the same to the main display of the MCCT
thermal power plant controller.