EVCO c-pro CLIMA sistema Installer manual - Manual (Page 28)

C-PRO CLIMA SISTEMA INSTALLER MANUAL
Page 28
5.2 Alarms/log menu
This menu contains the functionality linked to the controller alarms and the alarms log of the
system.
5.2.1 Alarms log
To view the system alarms log (MCCT regulator and MCZN regulators), press ENTER on
“hystorical alarms”.
If there are no elements present, “NO ALARMS” is displayed, otherwise the following page is
proposed, where the information of the last element memorised in the log is given:
To view the previous element, press ENTER on “>>”. By repeating this procedure, scroll all log
elements until the first element inserted is reached. From here, on request of the next element, the
last element memorised is re-proposed: the log display is circular.
To exit the log pages, press the ESC key or wait 60 timeout seconds. This level is not protected by a
password.
5.2.2 Reset active alarms
To view the active alarms of the MCCT regulator, press ENTER on “Rst running alarms”.
If there are no alarms present, “no alarms is displayed, otherwise a series of pages appear
containing all possible alarms present in the controller with relative codes and description.
The alarm or the alarms present, will be highlighted by flashing "Rst ALARM", as shown in the
figure below.
If the ESC key is pressed from an alarm page or 60 timeout seconds are allowed to pass, you go
back to the main page of the application. This level is not protected by a password.
5.2.3 Reset alarms log
To reset the memorised alarms log, press ENTER on “Rst hyst. alarms” and take the value of the
“Do you want to erase hystorical alarms memory?” parameter to the “Yes” value.
To exit the alarms log reset pages, press the ESC key or wait 60 timeout seconds. This level is not
protected by a password.
Ok: correct reading
Empty: memory empty
Overflow: memory full
Error: log reading failed
Log state
Date and time of the alarm
Progressive number memorised
Alarm code and origin network node