EVCO c-pro CLIMA sistema Installer manual - Manual (Page 62)

C-PRO CLIMA SISTEMA INSTALLER MANUAL
Page 62
8.4.5 Set-point menu
From this menu it is possible to display and set the temperature work set-point for the DHW tank
and for the AUX1 auxiliary circuit.
If the ESC key is pressed from a setting page or 240 timeout seconds are allowed to pass, you go
back to the main page of the application. This level is not protected by a password.
8.4.6 Maintenance menu
The maintenance menu is level 1, i.e. used to insert the maintenance level password or higher in
order to display/modify the parameters present in this branch.
From this menu it is possible to enable and set all features relative to the functions linked to the
DHW tank and the DHW circuits, solar panels and auxiliaries, contained in the MCPS application
and precisely.
Entering the GENERAL PARAMETERS menu, it is possible to enable/disable and set the parameters
relative to the execution of the Antigrip and Antilegionella cycles, as well as the calibration of the
signals coming from the temperature probes.
From the PANELS MAINTENANCE menu, it is possible to enable/disable and set the parameters
relative to the periodic activation cycles of the solar panels heat pumps and the solar panels
Antistagnation function. The activation/deactivation differentials of the pumps are set as well as the
minimum and maximum temperature limits for the two circuits.
The AUX 1 MANAGEMENT menu allows to set the parameters relative to the management of the
Auxiliary, defining the circulation pump activation mode, the plant type where it is placed, the
water work set-point, its differential and the calibration of the auxiliary probe.
Entering the DHW MANAGEMENT menu, it is possible to set an activation delay of the DHW
circuit circulation pump.
For all flow switches present in the MCPS application, the FLOW SWITCHES menu allows to set a
delay time from machine ON, a delay time in normal conditions and the number of alarms with
manual rearm in order to pass to the necessity for automatic rearm of the alarm.
The MANUAL menu allows to set the functioning of the utilities managed by the application in
manual/automatic mode, thus forcing the state, to test its functionality.
Finally, the TIME COUNTER menu allows to display, enable, set and reset the functioning hours
and the maintenance requests for the users to manage the MCPS application.