EVCO c-pro CLIMA sistema Installer manual - Manual (Page 29)

C-PRO CLIMA SISTEMA INSTALLER MANUAL
Page 29
5.3 Clock menu
From this menu it is possible to set/modify the value of the date and real time that the c-pro mega
MCCT controller propagates to the entire c-pro CLIMA system.
To set/modify the date and/or real time, press ENTER on “Real time clock” and set the desired
value, as shown in the following figure.
If the ESC key is pressed from a setting page or 60 timeout seconds are allowed to pass, you go
back to the main page of the application. This level is not protected by a password.
5.4 Maintenance menu
The maintenance menu is level 1, i.e. used to insert the maintenance level password or higher in
order to display/modify the parameters present in this branch.
In this menu it is possible to view and set the state of the various devices, inputs and outputs used
by the MCCT application.
Entering the GENERAL PARAMETERS menu, it is possible to view/enable/define the features
relative to functioning of the digital control digital inputs, summer/winter functioning mode
changeover (from keyboard, from digital input, from BMS or automatic), relative to the antigrip
function, management of the flow switches for the delivery pumps and the temporary disabling of
the zone controllers.
Entering the DELIVERY LINES menu, it is possible to view/define the features relative to the
functioning of various utilities present and enabled in the controlled system such as the type of
delivery lines, the management and the presence of the mixing valve, the management of delay
times on activation/deactivation of the utilities, the definition of the standard delivery set-points and
the set-points of the mixing valve, the definition of the temperature and calibration alarms of the
input probes.
The MANUAL menu allows to set the functioning of the utilities managed by the application in
manual/automatic mode, thus forcing the state, to test its functionality.
Finally, the TIME COUNTER menu allows to display, enable, set and reset the functioning hours
and the maintenance requests for the users to manage the MCCT application.