KEYENCE IV Series - Manual (Page 67)

5-9 - IV Series User’s Manual (Field Network) -
Data I/O communication setting method
11
Click the [Properties] tab. Select
[PROFINET interface [x1]] - [Ethernet
addresses] under [General], and then
select the IP address setting method for
the IV series.
z z
To set a new IP address for the IV series
using the DCP protocol
z z To use the IP address that is already
registered for the IV series
y If the IP address will be set by the DCP
protocol, the IP address of the sensor will be
initialized.
y The IP address set by the DCP protocol will
be stored in the volatile memory.
When you restart the sensor, the sensor
will start up with its IP address in “----”
(unregistered) status.
12
Click the [Properties] tab. Select
[PROFINET interface [x1]] - [Advanced
options] - [Real time settings] in
[General], and then set the SendCycle
(communication cycle) for the data I/O
communication in [Update time].
13
Click the CPU in the [Devices] tab. Select
[Compile] - [All] and save the settings.
5
Data I/O communication