KEYENCE IV Series - Manual (Page 25)

3-3 - IV Series User’s Manual (Field Network) -
Cyclic communication setting method
Cyclic communication setting method
This following explains the setting method when
using the cyclic communication.
y To control the IV series using the EtherNet/IP
communication, select [Network connection] for
the sensor connection setting. When connected
directly, the field network settings will be greyed
out and disabled.
y If you have modified the protocol settings, the
connection with the sensor will be terminated
and then restarted.
Setting the IV series
You can configure the following settings for the IV
series using the monitor (IV-M30) or IV-Navigator
(IV-H1).
When settings on the monitor (IV-M30)
Set the field network settings of the sensor to
[EtherNet/IP].
1
Tap the [Sensor Advanced] button on the
Sensor Setup Menu screen.
2
Tap the [Environmental] button, and then
the [Adv. Network Settings] button.
3
Tap the [Settings] button in the “Field
Network”.
4
Select [Ethernet/IP] for the protocol.
5
To enable the handshake control, select
[Enable].
y When the protocol is set as [Disable],
this setting item is shaded and cannot be
selected.
y When the data handshake control is set
as [Enabled], the status result will not be
updated until [Result acquisition complete
notice] (“Address2, Bit0” of Output Assembly)
is input.
“Operating procedure of the cyclic
communication” (Page 3-26)
6
After the setting is completed, tap the [OK]
button.
3
Cyclic communication