Elektron Octatrack - Manual (Page 179)

B-14 Appendix B: EFFECTS REFERENCE
SPRING REVERB
This effect is based on a classic spring reverb. It adds a grungy and “twangy” reverberation to the
incoming signal.
SPRING REVERB MAIN
TIME sets the decay time of the springs.
HP controls the cut off frequency of the high
pass filter of the springs.
LP controls the cut off frequency of the low
pass filter of the springs.
MIX adjusts the balance between the dry and
reverberated signal.
SPRING REVERB SETUP
TYPE sets the type of spring going from
slightly transparent to more springy in three
steps.
BAL sets the balance between the left/right
channel of the reverberated signal.