Elektron Monomachine User Manual
Quickstart guide: monomachine

QUICKSTART GUIDE: MONOMACHINE
PROGRAMMING
A
PATTERN
The Monomachine sequencer is very quick to operate. Is is possible to input
notes both on a 64-step grid and in real time. Here the
GRID RECORDING
mode will be explained.
1. The
RECORD LED (e) indicates whether GRID RECORDING mode is active
or not. A lit
RECORD LED means the mode is active. If the mode is not active,
activate it by pressing the
[RECORD] key(d) .
2. Select the first track by pressing the
[TRACK 1] key(g) .
3. Lit
TRIG LED's (i) indicate note trigs. Enter note trigs by pressing the
[TRIG] keys. If the track is longer than 64 steps of length, select the step range
that should be edited by pressing the
[SCALE SETUP] key (h) . If a note trig is
pressed and held, a little mini-keyboard will pop up in the lower left side of the
lcd screen. Here the pitch of the note trig is seen. While the
[TRIG] key of the
note trig is pressed and held the
[LEFT] and [RIGHT ARROW] keys (k ) can
be used to assign a new pitch value to the note trig.
4. Press
[PLAY]. When the running sequencer led hits the note trigs, the
machine assigned to track 1 will be trigged and therefore generate sound.
Notes can be entered and removed while the sequencer is playing.
PLAYING
A
PATTERN
The Monomachine can contain up to 128 patterns. Each pattern consists of six
internal tracks and six midi tracks. Each internal track contains a machine.
Machines either generate sounds or function as an effect.
1. Make sure the
MASTER VOLUME KNOB (a) is turned up.
2. Check so
BANK GROUP A-D (c) is selected. The BANK GROUP currently
selected is indicated by the two led's above the
[SLIDE] key. If BANK GROUP
A-D is not selected, press the [BANK] key (b) .
3. Choose pattern a01 by holding the
[PATTERN SELECTION] key (j) marked
A and pressing the first
[TRIG] key (m) . Pattern a02 is selected by pressing
the
[PATTERN SELECTION] key and [TRIG] key 2.
4. Press
[PLAY] (f) to listen to the pattern.
Patterns can be changed without having to stop the sequencer.
Open the
MUTE MENU by pressing and holding the [FUNCTION]
key and pressing the
[BANK] key. Mute individual tracks by pressing
the six leftmost
[TRIG] keys. Press the [TRIG] keys again to make the
tracks audible. Exit the
MUTE MENU by pressing [EXIT/NO] (l).
This quick start will guide you through some of the basic operations to allow you to start
using the Monomachine right away. Please visit www.elektron.se for Monomachine tutorial videos.
j
l
k
f
b
e
m
g
h
d
i
a
c
Please visit www.elektron.se for tutorial videos.