Ctrl 2 setup – Elektron Octatrack User Manual
Page 130
THE MIDI SEQUENCER
118
can then be set as usual by using the DATA ENTRY knobs. Disable the parameters again
by repeating the enabling procedure.
CC5-CC10 controls the values that should be sent for the CC commands specified in the
CTRL 2 SETUP page.
CTRL 2 SETUP
Here the CC commands whose values are controlled in the CTRL 2 MAIN page are
selected. Settings in this menu are adjusted just like when in CTRL 1 SETUP.
CC5-CC10 specifies the CC commands that will be controlled on the CTRL 2 MAIN page.
MIDI CC LEARN is available here as well.
This manual is related to the following products: